Sourdough Starter As Made By Johnny Vancora Recipe By Tasty

SOURDOUGH STARTER RECIPE BY TASTY

Steps:

• Day 1: Add 50 grams whole wheat flour, 50 grams bread flour, and 100 grams warm water to a clear lidded container with a capacity of 1 pint or more. Mix until there are no dry spots. Scrape down the sides of the container with a spatula. Cover with a lid.
• Use a rubber band or piece of tape to mark the mixture level. This will allow you to track any movement (eventually it will grow!) Set the starter in a warm spot. Let sit for 24 hours.
• Day 2: After 24 hours, open the container and look for signs of fermentation in the form of bubbles on top, volume growth, and/or a funky, slightly sweet acidic smell. If you see some of these signs, proceed to the next step. If not, cover the starter again and let sit for another 12-24 hours, until these signs appear. If the temperature in your house is cool, it may take a bit longer.
• Once the starter has gotten a bit bubbly and funky, it is time to discard and feed. Discard all but about 25 grams (2 tablespoons) of starter (see Note below on how to minimize waste!). Add another 100 grams warm water and stir to dissolve the remaining starter. Add 50 grams of bread flour and 50 grams of whole wheat flour and stir until there are no dry spots. Cover and let sit in a warm spot for another 24 hours.
• Days 3-15: Repeat the feeding process every day for 7-14 days. Eventually, a few hours after feeding, the starter will begin to grow, almost doubling in size, then deflate again. Once your starter is rising and falling regularly, it is in a good place.
• To test the readiness of the starter, do a float test: Fill a cup with cool water. Use a clean spoon to take a scoop of the starter (be careful not to stir the starter and deflate the air bubbles that make it float) and carefully plop it in the water. If it floats, it is gassy and alive and ready to make some bread! If not, don't despair, it can take a while to get going. Either wait longer if it has only been a few hours since feeding, or if it has been closer to 24 hours since feeding, discard and feed again.
• After passing the float test, the starter is ready to use for baking! You may find you like to use your starter when it is young, only a few hours after feeding when it just passes the float test. At this point it will smell sweet. If you want a more sour taste, use the starter 6-12 hours after feeding, when it will be more mature and smell a bit more vinegary and funky. This is up to you!
• Mold: If you see any fuzzy moldy spots on your starter that are black, red, or blue, unless it is very easy to scrape them off the top, unfortunately you need to start over. Sometimes, a while after feeding or being in the refrigerator, the starter will develop a dark, clear liquid on top. This is called hooch and is harmless. Just pour the liquid off!
• Flour: Use what you have. If you only have all-purpose flour, you can use that. If you only have bread flour, use that. If you only have whole wheat flour, you can use that, just know that you may need to feed more often because it gets funky more quickly.
• Discard: It may be tempting not to discard most of your starter every time you feed it because you don't want to waste, but we discard for a variety of reasons. We are giving the starter a lot of fresh food and water to eat. If we don't discard, the starter will retain a lot of that funkiness and also eventually grow to be huge if you just keep adding water and flour to it. I like to discard into another container and keep that container in the refrigerator until I need it for other baking projects. You can fold the discard into banana bread, pancakes, cookies, etc.
• Storage: Once your starter is up and running, you can either keep it at room temperature and feed it daily, or store it in the refrigerator. To store in the refrigerator, do a regular discard and feed, then place in the refrigerator. A day before you want to begin making bread, pull the starter out and let it come to room temperature. Then, discard and feed as usual.
• Scaling: This starter recipe calls for equal amounts of water and total flour by weight. You can scale this recipe up or down as needed, depending on how much starter the recipe you are going to make calls for.
• Enjoy!

SOURDOUGH BREAD FOR BEGINNERS RECIPE BY TASTY

Steps:

• Autolyse: Add 400 grams of warm water and the sourdough starter to a medium bowl. Stir with a rubber spatula to dissolve the starter.
• Add the bread flour and whole wheat flour. Use a spatula or your clean hands to mix until combined and there are no dry spots. Cover with a clean cotton kitchen towel and let sit in a warm place for 60 minutes.
• Bulk fermentation: After resting the dough, add the salt and remaining 10 grams water. Use your hands to incorporate the salt, squishing the dough through your fingers to make sure it is evenly distributed.
• Set a bowl of water nearby. Once the salt is incorporated, dip your hand in the water to prevent sticking. Use your wet hand to stretch the dough from the edge of the bowl upwards, then fold toward the center. Repeat a total of 8 times, rotating the bowl slightly after each fold.
• After the folds, carefully lift the dough up, flip it over, place it back in the bowl and tuck the edges under the dough. Scrape down the edges of the bowl, then cover with the kitchen towel and let rest in a warm place for 60 minutes.
• Repeat the stretching and folding process 2 more times, waiting 60 minutes after each folding session before beginning again. You should see signs of fermentation in the form of an increase in volume and bubbles along the edges and top of the dough. Wait a little longer, up to 30 more minutes between folds, if you don't see those signs yet.
• Preshape: An hour after the final stretch and fold, dip your hands in the water. Think of the dough as the face of a clock. Slide your hands into the bowl at 3 o'clock and 9 o'clock. Partially lift the dough from the bowl and let it fold under itself. Rotate the bowl and repeat the lifting and fold under 5-6 times, until dough has begun to come together in a ball.
• Carefully lift the dough onto a clean surface. Lightly sprinkle the dough with the dusting flour. Using a bench scraper, or lightly floured hands, carefully rotate and drag the dough towards yourself along the surface, building tension until you have a round, taut ball of dough. Do not make the ball too tight, as it may tear. Lightly flour the dough, cover with the towel, and let rest for 30-40 minutes.
• Final shape: Dust a proofing basket or a medium bowl lined with a cotton towel lightly with flour.
• After 40 minutes, the dough should look relaxed and have spread out slightly. Lightly flour the top of the dough again. Using the bench scraper, or a silicone spatula and lightly floured hands, carefully flip the dough over, so the unfloured part is facing upwards.
• Think of the clock again. Fold in 12 o'clock towards the center, then 6 o'clock, 3 o'clock, and 9 o'clock, then each of the remaining 4 diagonal corners. Carefully transfer the dough, seam-side up, to the prepared proofing basket or bowl. Pinch the seams to ensure they are sealed. Cover the bowl with the towel.
• Final proof: Transfer the dough to the refrigerator to finish proofing overnight, 12-18 hours. If you want to bake the same day, leave at room temperature for 2-3 hours, then transfer to the refrigerator while you preheat the oven. (Overnight proofing is highly recommended!)
• When you are ready to bake, preheat the oven to 500°F (260°C). Place a Dutch oven or cast iron combo cooker in the oven while it preheats. Make sure your oven has come up to temperature before baking, at least 30 minutes.
• Prepare a piece of parchment paper about the size of the bottom of your baking vessel. Place the parchment over the proofing basket and gently flip the basket over so the dough drops onto the parchment.
• Carefully remove the baking vessel from the oven. Use the parchment paper to carefully lift the dough into the pan. Use a sharp paring knife or bread lame to slash the top of the dough a few times. This scoring will allow steam to escape. Cover the vessel with the lid and carefully place in the oven.
• Bake for 25 minutes, then remove the lid and reduce the oven temperature to 450°F (230°C). Continue baking for another 15-20 minutes, until the crust is amber brown.
• Remove the bread from the oven and carefully transfer to a wire rack. Check to make sure it is done baking by tapping on the bottom--you should hear a hollow sound. Though it may be tempting to dive right in, let the bread cool completely, at least 2 hours, before slicing with a serrated knife.
• Store the loaf cut-side down on a cutting board, or in a plastic bag. You can freeze the whole loaf, or pre-slice, then freeze and pull out slices as needed.
• Notes: If you are using all-purpose flour, use 375 grams of water instead of 400 grams of water for the initial mix. If you don't have a Dutch oven or cast iron combo cooker, you could bake in a cast iron skillet, a pizza stone or a sheet pan, uncovered. You could also bake the bread in a greased 9 x 5-inch (22 x 12 cm) loaf pan (place the bread in the pan seam-side down instead of in a proofing basket.) Bake at 475°F (240°C) for 40-45 minutes, until amber brown. Reduce the oven temperature for the last 20 minutes of baking if the bread is getting too dark on top. The bread won't look as shiny and have as crispy of a crust, but will taste just as good!
• Enjoy!