Serviettenapkin Folding Sydney Opera Fan In Wine Glass Recipes

SERVIETTE/NAPKIN FOLDING, FLEUR DE LIS VARIATION.

Steps:

• Lay your serviette out flat before you in a diamond shape.
• Bring the corner at the South point up to meet the North point. you should have before you a triangle shape with the crease at the bottom.
• Fold the East point of the triangle up to meet the North point, repeat with the West point. You will now have a diamond shape with a vertical gap running down the centre.
• Take the South corner and bring it towards the North point but stop 3/4 of the way up, crease it well at the bottom now then take the same point and bring it back over itself to the bottom center of the triangle.
• Carefully turn the serviette over and tuck the East/West points into each other.
• Turn serviette over to the front side and gently fold down the two side flaps, creating a Fleur de Lis type of serviette that has a the addition of a decorative cuff at the base.

SERVIETTE/NAPKIN FOLDING, A NECK TIE FOR DAD...

Steps:

• Lay your serviette out flat before you in a diamond shape.
• Take your finger and place it half way between the West and South points, and about 1 inch toward the centre of the serviette. Next, Take the East point at bring it to the point where your finger is. Don't crease this fold (yet).
• Now take the West point of the serviette and bring it over to the East side so that both sides of this new diamons shape are even. Youmay have to adjust the first fold a little to get it looking good, once they are both ok, you can crease both the folds.
• You will have a very fat tie shape.
• Repeat the previous step again completely and you will have a smaller tie shape in front of you now.
• Take the top third of the tie (the narrowest bit) and fold it under and over itself horizontally (the end tip should be tucked undernieth) and the top should now look like the knot of a formal neck tie.
• Place on a plate and surprise the men in your life!

SERVIETTE/NAPKIN FOLDING, TIED IN A LOOSE KNOT.

Steps:

• Lay your serviette square out flat before you in a diamond shape.
• Fold the North point of the diamond down to meet the South point of the diamond. You will now have a triangle shape that's pointing downwards.
• Take hold of the South points and start rolling them up towards the North point, stopping fractionally short of the crease at the top.
• Loop the right hand end over the left hand end, pull the right hand end though the resulting hole to form a loose knot.
• Don't pull the knot too tight, just enough to be pleasing and informal.

SERVIETTE/NAPKIN FOLDING, SIMPLE STANDING FAN

Steps:

• Lay your serviette out flat and square before you.
• Take the top and bottom left hand corners and fold them over to the top and bottom right hand corners so that you now have a vertical rectangle before you, with the crease on the left.
• Starting at the bottom left and bottom right corners, accordion fold the serviette upwards to just past the half way point of the rectangle. (ironing the folds helps them to keep their shape).
• Now take the right side corner edge of the accordion folded strip and fold it over to the left side corner edge of the accordion strip so that the strip is now folded in half. There will be a square shape that is folded in half hanging out at the back.
• Holding the folded accordion pleats firmly, take hold of the top right corner of the square flap at the back (this corner has two open points, no fold line) and fold it over to meet the bottom left point of the square (right next to the accordion fold where it is folded in half), it should overlap the bottom of the square just a little.
• Now take that little overlapping flap and tuck it under the bottom of the square, that should secure things so that the serviette will stand up well.
• Carefully stand the serviette up and fan out the accordion pleats, the square part will be at right angles out at the back and stabilizes the fan as it stands up.
• Present it standing on a plate.

SERVIETTE/NAPKIN FOLDING, SIMPLE FAN VARIATION

Steps:

• Lay your serviette square out flat before you.
• Take the bottom right and left corners and make an accordion fold strips all the way up to the top right and left corners. If you press these with an iron the pleats will be nice and sharp. Leave unironed for a wavy casual look. (but ironed looks neater) You will now have a thin band the width of your accordion fold.
• Fold the serviette in half so that is is now half it's length and slip a serviette ring over the fold end of the accordion strip and pull gently about 1 inch ( 2.5 cm) up.
• Fan out the accordion pleats at the top to make a pleasing balance to the serviette. Present on a plate.

SERVIETTE/NAPKIN FOLDING, FRENCH PLEAT WITH POCKET

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the original square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the loose edges pointing upwards. We will call this the North corner.
• Take the topmost of these points and make a relatively tight roll towards the South position, at about the half way point you won't be able to roll any further and you will have a diagonal neat cuff going east/west across the diamond shape.
• Now take the next loose corner at North and gently bring it South, tucking it underneath the cuff that you just made in the previous step but leaving a pleat showing above, the same width of the cuff below. You will now have two diagonal neat cuffs/pleats going east/west across the diamond shape.
• Then take the next loose point at North and bring it to the South position, and still holding the point, start rolling it under itself heading towards the North position, at about the half way point you won't be able to roll any further and you will have a third horizontal neat cuff going east/west across the diamond shape that's next to the second one.
• Rotate your diamond shape so that the North point is now the top right corner and you have a square shape in front of you with three diagonal pleats running from the top left corner to the bottom right corner.
• Gently turn the serviette over and bring the top right and bottom right corners into the center. Repeat with the top left and bottom left corners.
• Turn back to the front side and you will have a very neat rectangle that has three diagonal pleats running across it.
• An elegant and stylish serviette that will impress any guest.

SERVIETTE/NAPKIN FOLDING, SYDNEY OPERA FAN IN WINE GLASS

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the original square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the open corner pointing upwards. We will call this the North corner.
• Take the East corner and make an accordion fold all the way to the West corner.
• Holding it firmly, gently pull out each of the 4 loose edges at the North point, fanning them out from left to right.
• Roll up the south corner a little to help the fan to keep its shape and place in a water or wine glass.