Serviettenapkin Folding Simple Fan Variation 2 Recipes

SERVIETTE/NAPKIN FOLDING, MARIE'S LILY PAD VARIATION, LOTUS

Steps:

• Lay your serviette square out flat before you in a square shape.
• Take the top right corner and fold the point into the center point of the square. Repeat with the other 3 corners. You should have a diamond shape in front of you.
• Take the East point of this diamond and fold it into the center point, and repeat with the other 3 corners. The serviette will be square again and have gaps in the form of an X.
• Carefully turn the serviette over and fold each of the corners into the centerpoint again.
• Carefully turn it over and you will see 4 loose points on the underside.(this step is only to make the next step clearer).
• Turn back over to the previous side, lay the serviette down and press firmly on the center point where the 4 corners meet. Carefully reach undernieth with your other hand and grab one of the loose points on the underside and bring it to the outside of the corner that it belongs to. This creates the outer petal of that quarter of the flower.
• Repeat with the other 3 corners.
• At this point you have the napkin that I call Marie's Lily Pad Flower. but the Lotus calls for an extra step.
• Reach undernieth again and you will find a second layer of 4 flaps on the bottom, gently pull them out to the front side ( hold the centre points firmly so that everything stays intact) and you will have a fuller looking flower that has additional petals/ leaves at the sides, inbetween the main petals. This addition turns the napkin into a "Lotus".

SERVIETTE/NAPKIN FOLDING, SIMPLE FAN VARIATION

Steps:

• Lay your serviette square out flat before you.
• Take the bottom right and left corners and make an accordion fold strips all the way up to the top right and left corners. If you press these with an iron the pleats will be nice and sharp. Leave unironed for a wavy casual look. (but ironed looks neater) You will now have a thin band the width of your accordion fold.
• Fold the serviette in half so that is is now half it's length and slip a serviette ring over the fold end of the accordion strip and pull gently about 1 inch ( 2.5 cm) up.
• Fan out the accordion pleats at the top to make a pleasing balance to the serviette. Present on a plate.

SERVIETTE/NAPKIN FOLDING, CANDLE FAN FOLD

Steps:

• Lay your serviette out flat and square before you.
• Bring the top and bottom right corners into the top and bottom centre of the serviette so that there is a vertical line running down the middle. Repeat with the left top and bottom corners. You should have before you a tall rectangle with a vertical gap running down the middle.
• Place your finger in the very centre of the serviette where the two flaps meet each other. With your other hand take the top right flap and pull it to the right, going past the top of the rectangle so that it make a triangle shape a little like the flap on a collar. Repeat with the top point on the left side. It now looks like the collar on a shirt with rather a wide neck at the back.
• The next step involves making a mirror image of the last step at the bottom, if it's easier then carefully turn your serviette around do that the collar is at the bottom upside down and then just repeat the previous step at the top as before. Once all four flaps are completed you will have before you a rectangle that has 4 triangles radiating out from the centre a little like a windmill.
• Starting at the bottom upside down collar part, take the bottom left and right edges and roll them as tightly as you can up to the centre of the serviette.( I set a glass on mine to keep it there while I did the next step).
• Turn the entire serviette around to the that roll is at the top and the collar bit of the top half is now upside down at the bottom.
• Accordion fold the bottom bit up to the centre (it will meet the roll at the middle).
• Now gather both ends (without letting it all unfold) and the roll should be in the middle.
• Place it into an empty water or wine glass and fan out the accordion fan bits at each side. So easy!

SERVIETTE/NAPKIN FOLDING, FRENCH PLEAT WITH POCKET

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the original square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the loose edges pointing upwards. We will call this the North corner.
• Take the topmost of these points and make a relatively tight roll towards the South position, at about the half way point you won't be able to roll any further and you will have a diagonal neat cuff going east/west across the diamond shape.
• Now take the next loose corner at North and gently bring it South, tucking it underneath the cuff that you just made in the previous step but leaving a pleat showing above, the same width of the cuff below. You will now have two diagonal neat cuffs/pleats going east/west across the diamond shape.
• Then take the next loose point at North and bring it to the South position, and still holding the point, start rolling it under itself heading towards the North position, at about the half way point you won't be able to roll any further and you will have a third horizontal neat cuff going east/west across the diamond shape that's next to the second one.
• Rotate your diamond shape so that the North point is now the top right corner and you have a square shape in front of you with three diagonal pleats running from the top left corner to the bottom right corner.
• Gently turn the serviette over and bring the top right and bottom right corners into the center. Repeat with the top left and bottom left corners.
• Turn back to the front side and you will have a very neat rectangle that has three diagonal pleats running across it.
• An elegant and stylish serviette that will impress any guest.

SERVIETTE/NAPKIN, DRAMATIC FAN

Steps:

• Place your serviette flat before you in a square shape.
• Carefully make accordion pleats from the very bottom of the serviette to the very top. You will have before you a long thin rectangular strip of pleated material.
• Starting at one end of the strip, carefully roll it up until you reach the 2/3 mark of the strip.
• Lay the spiral shape down so that it sits upright and gently fan out the last section that isn't rolled up.
• Holding the rolled up spiral section firmly, reach into the centre of the spiral and pull it the beginning edge and form it into a a small peak in the center.
• Arrange the serviette on a plate for dramatic effect.

SERVIETTE/NAPKIN FOLDING, SIMPLE STANDING FAN

Steps:

• Lay your serviette out flat and square before you.
• Take the top and bottom left hand corners and fold them over to the top and bottom right hand corners so that you now have a vertical rectangle before you, with the crease on the left.
• Starting at the bottom left and bottom right corners, accordion fold the serviette upwards to just past the half way point of the rectangle. (ironing the folds helps them to keep their shape).
• Now take the right side corner edge of the accordion folded strip and fold it over to the left side corner edge of the accordion strip so that the strip is now folded in half. There will be a square shape that is folded in half hanging out at the back.
• Holding the folded accordion pleats firmly, take hold of the top right corner of the square flap at the back (this corner has two open points, no fold line) and fold it over to meet the bottom left point of the square (right next to the accordion fold where it is folded in half), it should overlap the bottom of the square just a little.
• Now take that little overlapping flap and tuck it under the bottom of the square, that should secure things so that the serviette will stand up well.
• Carefully stand the serviette up and fan out the accordion pleats, the square part will be at right angles out at the back and stabilizes the fan as it stands up.
• Present it standing on a plate.

SERVIETTE/NAPKIN FOLDING, SYDNEY OPERA FAN IN WINE GLASS

Steps:

• Lay your serviette square out flat before you. Fold it in half horizontally.
• Take the serviette and fold it in half again vertically so that it is now a small square a quarter the size of the original square.
• Only one corner of the square will have 4 open / loose edges, rotate your square so that it is a flat diamond shape with the open corner pointing upwards. We will call this the North corner.
• Take the East corner and make an accordion fold all the way to the West corner.
• Holding it firmly, gently pull out each of the 4 loose edges at the North point, fanning them out from left to right.
• Roll up the south corner a little to help the fan to keep its shape and place in a water or wine glass.