Pressure Cooker Pot Roast Recipes

PRESSURE COOKER POT ROAST

Steps:

• Bring chuck roast to room temperature, then season well with salt and pepper.
• Heat the Instant Pot using the sauté setting. Once hot, add oil, then sear roast on both sides. Set aside.
• Add 1 onion and celery to pot and cook for 2 minutes, until soft and translucent. Then add garlic, thyme, rosemary, and bay leaf - continue cooking for 1 minute.
• Add red wine to deglaze the pot, making sure to scrape up all bits. Let wine simmer for at least 2 minutes.
• Add roast, then add enough broth so that the roast is just barely covered.
• Lock lid and cook for 75 minutes at high pressure. Once time is complete, let pressure naturally release (about 30 minutes).
• Carefully remove roast and set aside to rest.
• Using a fine mesh strainer, pour liquid into separate container, then return to pot. Discard aromatics.
• Add sliced onion, carrots, and potatoes to pot and close lid.
• Lock lid and cook for 4 minutes at high pressure, then quick-release pressure.
• Meanwhile - In a small dish, combine cornstarch and water. Once cook time is complete, open lid, switch to sauté setting, and add cornstarch slurry to pot. Cook until desired consistency is achieved (2-3 minutes).
• Return roast to pot and pull apart meat as much as you like.
• Serve together and enjoy!

PRESSURE COOKER POT ROAST

Steps:

• Season the beef generously all over with about 1 tablespoon salt. Using the sauté setting, warm the oil in a 6- to 8-quart electric pressure cooker. Add one chunk of the beef and sear one side until deeply browned, about 5 minutes. Remove the first chunk and repeat with the remaining chunk, searing one side. (You can brown more than one side of each chunk, but one side is enough to build flavor without spending too much time on this step.) If the pressure cooker gives you a "hot" error, simply turn it off and use residual heat to cook. When it cools, turn the sauté setting back on.
• Add the pearl onions and garlic; season with salt and pepper. Cook, stirring, until the garlic is softened, about 2 minutes. Pour in the wine, vinegar and 1/2 cup water; season generously with black pepper and lightly with salt. Using a metal or wooden spoon or spatula, scrape up all the browned bits on the bottom of the pot. Turn off the sauté setting. Add the herbs and nestle the beef into the liquid. Cook on high pressure for 1 hour.
• Make the pickled onions, if desired: Bring the vinegar and sugar to a boil in a small saucepan. Add the pearl onions and a generous pinch of salt and cook, stirring, to dissolve the sugar and warm the onions through, about 1 minute. Remove the mixture from heat and set aside at room temperature to pickle for at least 1 hour. (You can make the pickled onions up to 5 days ahead; store them in a sealed container in the refrigerator.)
• Allow the pressure to reduce naturally for 10 minutes, then release the remaining pressure manually. Add the vegetables to the pot, tucking them below the liquid. Cook on high pressure until the beef and vegetables are both tender, an additional 4 minutes. Quick-release the pressure by twisting the pressure knob to vent, then open the lid. Using tongs and a slotted spoon, remove the beef and vegetables to a serving platter. Break the beef into large chunks to serve. At this point, you can simply drizzle some cooking liquid over the top of the beef and vegetables, and top with the drained, pickled pearl onions to serve. Discard the remaining cooking liquid or strain it, refrigerate it, discard the layer of fat and freeze the remaining liquid as beef stock.
• If you'd prefer a thicker gravy, strain the cooking liquid and return it to the pot. Using the sauté function, bring it to a boil. Meanwhile, combine the butter and flour in a small bowl and knead it together with your fingers until it is uniform, almost like a dough. Once the liquid is boiling, drop the butter-flour mixture into the pot, whisking well to combine. Let it bubble until it is lightly thickened, about 5 minutes, then drizzle some gravy over the pot roast and vegetables, and top with drained, pickled onions. Serve extra gravy on the side.

PRESSURE-COOKER POT ROAST

Steps:

• Heat oil in a 6-to-8-quart pressure cooker over medium-high, or in an electric pressure cooker set to saute. Pat beef dry and season with 1 teaspoon salt and 1/2 teaspoon pepper. Add beef and cook until browned on all sides, 8 to 10 minutes; transfer to a plate. Pour out all but 2 tablespoons fat (or add enough oil to equal 2 tablespoons). Add garlic and flour, and cook, stirring, until fragrant, 1 to 2 minutes. Whisk in stock, carrots, olives, dates, thyme, bay leaf, cumin seeds, orange zest and juice, and 1 teaspoon salt. Return beef along with any accumulated juices to pressure cooker.
• Stovetop: Secure lid. Bring to high pressure over medium-high heat; reduce heat to maintain pressure and cook for 60 minutes. Remove from heat, quickly release pressure, then remove lid.Electric: Secure lid. Manually set cooker to 90 minutes and let it come to pressure. Once time is complete, turn off, quickly release pressure, then remove lid.
• Let beef stand in liquid 10 minutes. Skim any fat from surface. Transfer beef to a serving platter. (Discard bay leaf.) Spoon sauce over and around beef and serve.

JEN'S PRESSURE COOKER POT ROAST

Steps:

• Season roast with salt and pepper on all sides; coat roast with flour (reserve leftover flour for gravy).
• Melt shortening in a pressure cooker over medium-high heat. Brown roast on all sides in hot shortening. Sprinkle onion soup mix over the roast. Pour in at least two cups of water; use 1 to 2 cups more if the beef is a tough cut or to reach the minimum amount recommended by the pressure cooker's manufacturer.
• Seal the lid and bring the cooker up to full pressure over high heat. Reduce the heat to low, maintaining full pressure, and cook for 1 1/2 to 2 hours.
• Release the pressure and test for doneness; the meat should be fork-tender. Add potatoes and onions, making sure the vegetables are submerged in the cooking liquid. (You may need to rearrange the roast on top of the vegetables or add more water.) Seal the lid and return the pressure cooker to full pressure.
• Reduce heat to low, maintaining full pressure, and cook for 10 minutes. Release the pressure; transfer meat and vegetables to a serving platter.
• To make gravy, bring the cooking liquid to a boil. Whisk reserved flour into 1/2 cup cold water; whisk the flour mixture into the boiling broth. Cook until thickened, stirring occasionally, about 3 minutes. Serve gravy with pot roast and vegetables.

PERFECT PRESSURE COOKER POT ROAST

Steps:

• Heat oil in the pressure cooker over medium-high heat with the lid open. Brown the roast on all sides in the hot oil.
• In a small cup or bowl, mix together the Italian salad dressing mix, Ranch dressing mix, and gravy mix. Sprinkle them evenly over the roast. Pour in the beef broth and add the chopped onion.
• Seal and lock pressure cooker, and cook over high heat to build pressure until the indicator sounds (mine whistles). Turn heat down to medium, and cook for 45 minutes. Remove from heat and let stand for 5 minutes. Run under cold water to help release the pressure before unsealing the lid. You can use the juices as an au jus, or thicken with flour or cornstarch to make a yummy gravy.

PRESSURE-COOKER BLOODY MARY POT ROAST

Steps:

• In a large bowl or shallow dish combine 3/4 cup Bloody Mary mix, 1 tablespoon Worcestershire sauce, pepperoncini juice and 1/2 teaspoon celery salt. Add beef; turn to coat. Cover and refrigerate 4-5 hours, turning occasionally., Drain beef, discarding marinade. Select saute or browning setting on a 6-qt. electric pressure cooker. Adjust for medium heat; add oil. When oil is hot, brown roast on all sides; remove from cooker. Add onions; cook and stir until lightly browned, 4-5 minutes. Remove from cooker. Add stock to pressure cooker. Cook 1 minute, stirring to loosen browned bits from pan. Stir in tomato paste and the remaining 1/4 cup Bloody Mary mix and 1 tablespoon Worcestershire. Press cancel., Return roast and onions to cooker. Add celery, pepperoncini, garlic, pepper and remaining 1/2 teaspoon celery salt. Lock lid; close pressure-release valve. Adjust to pressure-cook on high for 45 minutes. Allow pressure to release naturally for 10 minutes; quick-release any remaining pressure. Remove roast to a serving platter; tent with foil. Let stand 10 minutes before serving. If desired, thicken cooking juices to serve with roast.

POT ROAST - PRESSURE COOKER

Steps:

• Rub the meat well with the crushed garlic, using one clove for each side.
• In a 5 quart or larger pressure cooker, brown roast well on all sides over medium-high heat. If it begins to smoke, reduce heat to prevent burning. Remove roast and set aside.
• Add oil and onion and cook until softened.
• Add beef broth, tomato paste, water, brown sugar, dry mustard, paprika, lemon juice, cider vinegar and Worcestershire sauce.
• Scrape bottom of cooker to remove any remaining bits of meat left over from browning. Stir well until all ingredients have dissolved and contents are boiling.
• Return roast to pressure cooker and turn to coat with sauce.
• Close lid and bring pressure cooker to high pressure over medium-high heat. Once full pressure is reached, reduce heat enough to maintain pressure.
• Cook for 1 hour.
• Remove from heat and use the Natural Release Method, leaving pot off of heat until pressure is subsided.
• Remove meat from pot and slice the meat and arrange on a serving platter, spooning some of the sauce over and sprinkling with parsley.

PRESSURE COOKER POT ROAST

Steps:

• Brown meat in oil in pressure cooker.
• Add rest of ingredients and cook 40 minutes.
• at 15 pounds pressure.