Homemade Honeycomb Recipe By Tasty

HONEYCOMB

Steps:

• Butter a 20cm square tin. Stir the caster sugar and golden syrup together in a deep saucepan over a gentle heat until the sugar has melted. Try not to let the mixture bubble until the sugar grains have disappeared.
• Once completely melted, turn up the heat a little and simmer until you have an amber coloured caramel (this won't take long), then as quickly as you can, turn off the heat, tip in the bicarbonate of soda and beat in with a wooden spoon until it has all disappeared and the mixture is foaming. Scrape into the tin immediately - be careful, the mixture will be very hot.
• The mixture will continue bubbling in the tin, simply leave it and in about 1 hr-1 hr 30 mins the honeycomb will be hard and ready to crumble or snap into chunks.

HOMEMADE HONEYCOMB RECIPE BY TASTY

Steps:

• Cover a baking tray with greaseproof paper. Set aside.
• Mix the sugar, syrup, and honey together in a saucepan.
• Turn up the heat and slide a thermometer into the mixture. Heat till the sugar mixture reaches 275°F (140°C) and is brown and bubbling.
• Take the thermometer out and quickly whisk in the bicarbonate of soda.
• Pour the honeycomb into the prepared tray and leave to set. Do not touch the honeycomb at all throughout.
• Once set, smash up the honeycomb into bite-size pieces.
• Dip into the melted chocolate and chill.
• Enjoy!

HOMEMADE HONEYCOMB

Steps:

• Butter the base and sides of a 20cm non-stick square cake tin. (If your tin isn't non-stick, butter, then line with baking parchment).
• Melt the sugar and golden syrup in a deep saucepan over a low heat, stirring. Don't let it bubble until the sugar has dissolved completely.
• Once melted, turn up the heat and bring to a simmer. Cook until you have an amber-coloured caramel (this won't take long, but if you have a thermometer, it needs to reach 150C, so it doesn't get sticky when stored). As quickly as you can, remove from the heat, add the bicarb and beat with a wooden spoon until it's all absorbed and the mixture is foaming. Immediately scrape into the tin, but be careful, as the mixture will be very hot.
• Leave to cool for 1-1½ hrs until the honeycomb is hard - it will continue bubbling in the tin as it cools. Break into chunks before packaging.

BUBBLE WRAP HONEYCOMB CAKE RECIPE BY TASTY

Steps:

• Make the honey buttercream frosting: In a large bowl, cream together the butter and cream cheese with an electric mixer on medium speed until well combined, scraping down the sides of the bowl as needed. Add the honey and beat to incorporate. Add the powdered sugar and a pinch of salt and beat on low until mostly combined. Increase the mixer speed to high and beat for 3-5 minutes more, until the buttercream is light and fluffy. If the frosting feels soft, you can also refrigerate it for 10-15 minutes so it stiffens slightly.
• Assemble the cake: Place a cardboard cake round on a cake turntable and dab a small amount of frosting in the center of the cardboard round. Center one yellow cake layer over the dab of frosting, then evenly spread about ½ cup of buttercream on top with an offset spatula. Top with a layer of chocolate cake, then another ½ cup of frosting. Repeat with the remaining cake layers and frosting. After adding the final layer, lightly frost the entire cake to create a thin crumb coat.
• Refrigerate the cake for 15 minutes.
• Cover the chilled cake with the remaining frosting in an even layer. Return the cake to the refrigerator for 15 minutes more, to allow the frosting to stiffen.
• Take the cake out of the refrigerator. With the bubbles facing outward so they don't get frosting on them, wrap the sheet of bubble wrap around the perimeter of the cake. Trim the wrap to form a collar that fits loosely around the cake and comes about 2 inches over the top edge. Remove the bubble wrap. Keep the cake in the refrigerator until you're ready to finish the assembly.
• Make the yellow candy honeycomb: Place the candy melts in a medium microwave-safe bowl. Microwave on medium power (not on high, which will cause the candy to seize) in 30-second intervals, stirring in between, until the candy is fully melted and smooth.
• Place the bubble wrap bubble-side up on a flat surface. Pour most of the melted candy along the bottom two-thirds of the bubble wrap. Working quickly, use an offset spatula to spread the candy over the bubble wrap, leaving the top third empty. Once the bottom two-thirds are evenly covered, use a spatula to spread the candy in a wave pattern along the top edge. Let sit for 5 minutes. While you wait, remove the cake from the refrigerator and position it near the bubble wrap.
• After 5 minutes, test the bubble wrap by lifting up a corner. If it looks like it is beginning to harden and has a sheen to it but is still pliable, it is ready to be used. If the candy is still very loose and dripping, let sit for another 1-3 minutes, checking every minute.
• Once the candy has set, pick it up by the top corners and quickly wrap the side with the candy around the cake. Press it onto the cake so it sticks. Once attached, try to slowly peel one corner of bubble wrap off. It it sticks, let sit for 1-3 minutes, checking every minute, until ready to peel. If it begins to peel, continue slowly peeling off the bubble wrap until entirely removed. If the candy cracks while you are peeling off the bubble wrap, either remelt and repeat the process, or break it into large shards to decorate the outside of the cake. Refrigerate until serving time.
• Immediately before serving, top the cake with homemade honeycomb pieces and crushed honeycomb. Drizzle honey around the edges of the yellow candy honeycomb.
• Carefully slice the cake. Drizzle each piece with more honey before serving.
• Enjoy!