Doughnut Holes 5 Ways Recipes

EASY HOMEMADE GLAZED DOUGHNUT HOLES

Steps:

• Sift the confectioners' sugar into a medium bowl. Slowly stir in 3 tablespoons of milk and the vanilla extract until the mixture is smooth. If the glaze isn't thin enough, stir in 1 additional tablespoon of milk. Cover the glaze with plastic wrap and set it aside while you make the doughnut holes.
• Add the vegetable oil to a large, heavy-bottomed pot. (There should be at least 2 inches of oil in the pot and at least 2 inches between the top of the oil and the top of the pot.) Attach the deep-fry thermometer to the pot and begin heating the oil over medium heat to 350ºF. Line a baking sheet with paper towels.
• In a small bowl, whisk together the milk and the egg.
• In a separate medium bowl, whisk together the flour, sugar, baking powder and salt. Stir the milk-egg mixture into the dry ingredients, then stir in the melted butter, mixing until a soft dough forms.
• Once the oil has reached 350ºF, use a small ice cream scoop to drop about 1 tablespoon scoops of dough into the oil, careful not to overcrowd the pan. (See Kelly's Notes.) Fry the doughnut holes, flipping them in the oil, for about 2 minutes or until they're golden brown. Using a slotted spoon, transfer the doughnut holes to the paper towel-lined baking sheet.
• Allow the doughnut holes to cool slightly. Place a cooling rack atop a baking sheet, then one by one, dip the doughnut holes into the glaze and transfer them to the rack to allow the excess glaze to drip off. Serve immediately.
• The dough expands when fried, so 1 tablespoon of batter will yield about a 2-inch doughnut hole. If you prefer smaller doughnut holes, drop about 1 teaspoon of batter into the oil. This recipe yields about 2 dozen of the larger doughnut holes or 4 dozen of the smaller variety.
• The roundness of the doughnut holes depends on how clean of a scoop of batter you drop into the hot oil. If you don't have a small ice cream scoop, you can use two small spoons to form the batter into mounds, however your doughnut holes will not be as uniformly round in shape.
• ★ Did you make this recipe? Don't forget to give it a star rating below!

DOUGHNUT HOLES 5 WAYS

Steps:

• In deep fryer or 2-quart heavy saucepan, heat 2 to 3 inches oil to 375°F. Place one of the Coating Flavors into a brown paper lunch bag (about 10 3/4 x 5 inches) or medium bowl.
• Lightly spoon Bisquick mix into measuring cup; level off with straight edge of knife. Add to medium bowl along with remaining Doughnut Hole ingredients; mix just until dough forms. Work with half of the dough at a time; cover and refrigerate remaining half of dough. Shape dough into 1-inch balls. Sprinkle fingers and hands with Bisquick mix if they get sticky. Carefully drop balls, 5 or 6 at a time, into hot oil. Fry 1 to 2 minutes or until golden brown all around; drain on paper towels. Immediately gently shake 2 or 3 doughnut holes at a time in bag, or roll in coating in bowl. Repeat with refrigerated dough.

HOMEMADE DONUT HOLES

Steps:

• Line a large baking sheet with a few layers of paper towels then top with a wire cooling rack. Set aside.
• Pour oil into heavy bottomed pan (dutch ovens or deep cast iron pans are fabulous for frying), until oil is about 2 inches deep. Heat over MED heat until oil comes up to 350 F degrees. Adjust heat level as needed to maintain the 350 degree temperature.
• While oil is heating, whisk together flour, sugar, baking powder, salt and nutmeg in a large mixing bowl. In a separate mixing bowl, whisk together the milk, egg and vanilla.
• Pour the wet ingredients into the mixing bowl with the dry ingredients and stir together for a few seconds with a wooden spoon. Add melted butter and stir until mixture forms a thick batter.
• Once oil has reached 350 F degrees, use a cookie scoop to scoop up batter and drop them into the hot oil. Be careful when dropping the batter, do it from just above the oil so you minimize splashing! Hot oil is no joke and it hurts like crazy if you get burnt!
• Add about 8 donut holes to the oil in one batch, and fry about 2 minutes per side. Remove fried donuts to prepared cooling rack/baking sheet.

DOUGHNUT HOLES 5 WAYS

Steps:

• In deep fryer or 2-quart heavy saucepan, heat 2 to 3 inches oil to 375°F. Place one of the Coating Flavors into a brown paper lunch bag (about 10 3/4 x 5 inches) or medium bowl.
• Lightly spoon Bisquick mix into measuring cup; level off with straight edge of knife. Add to medium bowl along with remaining Doughnut Hole ingredients; mix just until dough forms. Work with half of the dough at a time; cover and refrigerate remaining half of dough. Shape dough into 1-inch balls. Sprinkle fingers and hands with Bisquick mix if they get sticky. Carefully drop balls, 5 or 6 at a time, into hot oil. Fry 1 to 2 minutes or until golden brown all around; drain on paper towels. Immediately gently shake 2 or 3 doughnut holes at a time in bag, or roll in coating in bowl. Repeat with refrigerated dough.

DOUGHNUT HOLES 5 WAYS

Steps:

• In deep fryer or 2-quart heavy saucepan, heat 2 to 3 inches oil to 375°F. Place one of the coatings (ideas below) into a brown paper lunch bag (about 10 3/4 x 5 inches) or medium bowl.
• Lightly spoon Bisquick mix into measuring cup; level off with straight edge of knife. Add to medium bowl along with remaining Doughnut Hole ingredients; mix just until dough forms. Work with half of the dough at a time; cover and refrigerate remaining half of dough. Shape dough into 1-inch balls. Sprinkle fingers and hands with Bisquick mix if they get sticky. Carefully drop balls, 5 or 6 at a time, into hot oil. Fry 1 to 2 minutes or until golden brown all around; drain on paper towels. Immediately gently shake 2 or 3 doughnut holes at a time in bag, or roll in coating in bowl. Repeat with refrigerated dough.